Anchor
top
top
Overview

The following is the process on how to use SecureW2 on any device running Mac to connect to the Eduroam Wi-Fi.

To be able to connect to Eduroam, you will need to have some kind of internet connection before being able to connect properly.

Excerpt

Warning

title	MFA

To be able to successfully complete this process, you will need to have your MFA device near by for approval after sign in.

Connect to the USF-Guest Wi-Fi on your device.
Open a internet browser. You should be taken to https://guestwireless.net.usf.edu/Network_Registration/ automaticlly automatically.
Note
If you are not directed automatically to the web page above, you can visit http://neverssl.com to continue with the process.
Select Connect to EDUROAM.
Select Sign In.
Enter your NetID@usf.edu address and select Next
Enter your NetID Password and select Sign In.
Place a check mark in Don't ask again for 60 days. You will receive a approval request to your MFA Device that must be approved to continue.
Place a check mark in Don't show this again and select Yes.
Select JoinNow
Select Allow.
You will receive the below page once the download of the profile is completed. You will need to make sure that EDUROAM is selected within you list of Wi-Fi options.
Navigate to System Preferences on your computer.
Select Profiles.
Highlight University of South Florida under the downloaded section on the left column and then select Install.
Select Install.
Enter in your password to your Mac and select OK.
A the bottom left, you will see the message "Installing profile...".
Once the installation is complete, you will see your NetID@usf.edu account under SCEP Enrollment.
You should automatically be switched over to the Eduroam Wi-Fi. If you are not, then you can manually select it to connect.