Once you run a report you may only want to view a sub-set of the data. Filters are used to restrict the report data you want to retrieve and see. Filter options are based on your HART license. You can set a Quick Filter to define the data you want to use.
The following topics are covered:
Table of Contents
Set Filter
How to set a filter:
- Run a report.
- Right-click and select Filter, Add Filter.
- The Filter dialog box will display. Select the value you want to use for the filter. See figure 25 1 below.
Figure 251: Filter Dialog Box. Click image to enlarge. - Click OK.
Remove Filter
How to remove a filter:
- Right-click and select Filter, then Remove Filter.
- At the prompt "Are you sure you want to delete this filter?", select Yes.
| Tip |
|---|
REMOVING FILTERS |