Eduroam - SecureW2 on iPhone and iPad


The following is the process on how to use SecureW2 on an iPhone and/or iPad to connect to the Eduroam wifi. 

You will need to visit to perform this process.


To be able to successfully complete this process, you will need to have your MFA device nearby for approval after sign in.

  1. After navigating to, select Sign In.

  2. Enter your account and select Next.

  3. Enter your NetID Password and select Sign in.

  4. Place a checkmark at Don't ask again for 60 days and then approve your log in through you MFA method.

  5. Place a check at Don't show this again and select Yes.

  6. Select JoinNow.

  7. Select Allow.

  8. Once the profile has been downloaded successfully, select Close.

  9. You will be given instructions on how to install the new profile that was just downloaded.

  10. Navigate to your device Setting and select Profile Downloaded.

  11. Select Install.

  12. Select Install.

  13. Select Install.

  14. If the profile was downloaded successfully, you should see a message of Enrolling Certificate at the top.

  15. Select Done.

  16. Once complete, you will see University of South Florida as a new Configuration Profile.

  17. Navigate to your device's Wi-Fi to check to see if it connected automatically. If it did not, at this time, select eduroam to connect.

Back to top

If you are unable to solve your issue with this knowledge base article, please contact the USF IT Service Desk by calling (813) 974-HELP (4357) or emailing 

If you find any errors or omissions in any knowledge base article, please contact and inform the USF IT Service Desk by calling (813) 974-HELP (4357) or emailing